EMBER - Default mug name. Visible after double tap touch button when not set any custom name.
BATTERY COOLING - Warning info when battery temperature rise over 140°F (60°C), but is less than 142°F (61°C).
BATTERY COOLING. POWERING OFF - Warning info when battery temperature rise over 142°F (61°C).
BATTERY COLD - Warning info when battery temperature drops below 3°F (-16°C), but is greater than -2°F (-19°C).
TOO COLD. TURNING OFF - Warning info when battery temperature drops below -2°F (-19°C)
HELLO - During powering on the mug.
GOOD BYE - During powering off the mug.
EMPTY - When the mug detect that is empty. Empty detection is triggered just after power on the mug, after change target temp (limited to one per 3min) and when temperature rapidly drops.
COLD - When the mug detects that it isn’t empty, but the temperature of the liquid inside is less than 100°F and heating is not taking place. The mug displays COLD when:
1. Liquid inside is cooler than 100°F and the heater is not active.
2. The user manually sets the temp to COLD via the temp ring or the mobile app.
3. The mug is reset while containing liquid cooler than 100°F. The user must set a new temperature via the temp ring or the mobile app to begin heating.
OFF? - When user long press touch button when the mug is enabled. This is question for power off the mug which have to be confirmed by single tap on the touch button in order to turn off the mug.
PLEASE WAIT - After successful firmware update. Device holds other operation and create backup firmware image in external memory. To see this text, do firmware update with new image, after finally finished ad boot then after 10s should see "WAIT" for about 4s
PAIR - When user is in pairing mode. To enter to pairing mode turn off the mug and turn on holding touch button until see “PAIR"
UPDATING - When the mug is in update mode. To enter have to start firmware update.
ERROR - When some peripheral device doesn't respond, most probably caused by hardware issue
RESET - When hold for 10s reset button on the bottom of the mug. It restores image and remove all setup and paired devices
Battery icon with animation - When mug is connected to charger. Shows current level of the battery plus charging tip.
Battery icon without animation - When user tap three times on the mug’s touch button. Shows current level of the battery.
Battery icon outline - Displaying constantly on the mug’s display when battery level is critical (<10%). In this state heaters are disabled. When battery level drops even more (1%) the mug will automatically turns off. When turn on after that it will show battery outline for a moment and then turn off again.